2010 nissan altima wheel bearing replacement

How much does it cost to replace a wheel bearing on a Nissan Altima?

The average cost for a Nissan Altima wheel bearing replacement is between $224 and $466. Labor costs are estimated between $150 and $189 while parts are priced between $74 and $277 .

How much does it cost to replace back wheel bearings?

The cost of a complete rear wheel bearing replacement will be somewhere in area of $240 to $460. Parts will on average be between $100 and $180. The labor costs will be around $140 to $280.3 мая 2019 г.

How often do wheel bearings need to be replaced?

every 25,000 to 30,000 miles

How long will a wheel bearing last after it starts making noise?

How long does a wheel bearing last? Wheel bearings have an average lifespan of 136,000 to 160,000 km (approximately 85,000 to 100,000 miles). This is only a rule of thumb though, the actual lifespan of a wheel bearing depends on the quality of the wheel bearing and the operating conditions.

Can you drive with a bad wheel bearing?

Q: Is it safe to drive with a bad wheel bearing? A: No. It can, in fact, be very dangerous to drive if one of your bearings is worn out, especially since it may cause the wheel to stop while driving. Additionally, a damaged wheel bearing puts a lot of stress on the hub, the CV joint, and the transmission itself.14 мая 2019 г.

Can you replace just one wheel bearing?

After it’s diagnosed and you know for sure it’s a wheel bearing, your mechanic tells you “if one wheel bearing failed, you should replace both,” that’s just not true, and if your mechanic tells you that you need to replace both wheel bearings because one has failed, find a new mechanic!9 мая 2018 г.

You might be interested:  2014 nissan altima windshield wipers

How long can you drive with bad wheel bearings?

The heat would crash the wheel completely. To avoid this situation, it is recommended to drive at the slower speed so that your wheel stays in action a few more hours. SO, while thinking how long can you drive on a bad bearing? You should not go more than 1000 miles as it might result in some bigger issue.

How long does it take to replace a rear wheel bearing?

Factors Influencing Hub Assembly Installation

For new technicians, turnaround time can be up to two hours. However, that time can be cut in half by experienced technicians, especially if there are no delays in acquiring parts or tools.

Leave a Comment

Your email address will not be published. Required fields are marked *