2008 nissan altima brake switch replacement

How much does it cost to replace brakes on a Nissan Altima?

The average cost for a Nissan Altima brake pad replacement is between $249 and $268. Labor costs are estimated between $74 and $94 while parts are priced at $174 .

What are the symptoms of a bad brake switch?

One of the symptoms commonly associated with a bad brake light switch are brake lights that stay on at all times. If the brake light switch shorts internally it may cause the brake lights to stay illuminated, even when the pedal is not being pressed.

Where is the brake switch on a Nissan Altima?

The switch is at the top of the brake pedal.

How long do Nissan Altima brake pads last?

How long do Nissan Altima brake pads last? Nissan Altima brake pads usually last between 30,000 and 70,000 miles depending on your driving habits. If you commute in heavy traffic and use your brakes often, you’ll need to get an inspection more frequently.

What are the best brake pads for Nissan Altima?

Some of the highest-rated Bosch Brake Pads & Shoes products that will fit your Nissan Altima are:

  • Bosch QuietCast Ceramic Pads w/ Hardware and Shims. Rear Brake Pads. $57.07.
  • Bosch QuietCast Premium Brake Pads – w/ Hardware and Shims. Rear Brake Pads. …
  • Bosch QuietCast Premium Brake Pads w/ Shims. Rear Brake Pads.

How much does it cost to fix a brake switch?

A replacement brake light switch generally costs around $30 to $75, depending on the make and model of the vehicle. Getting a brake light switch fixed at a shop will add typically $80 to the repair.

You might be interested:  2007 nissan versa headlight bulb size

What are the two switches on my brake pedal?

The brake light switch serves two major functions. First, it turns on the brake lights when a driver presses the brake pedal. Second, it sends the signal to the vehicle computer that brakes are applied. A car with a faulty brake light switch is UNSAFE to drive.

What would cause cruise control to stop working?

When the fuse of for the cruise control blows, the cruise control will stop working altogether. … A vehicle’s cruise control may stop working if the vacuum actuator has stopped working or if there is damage to the vacuum hoses. The system may also fail if the cable linking the actuator to the throttle is broken.

What can cause a Nissan Altima not to start?

While there are a variety of reasons your Nissan Altima won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.

Where is the brake switch located?

You can see your brake light switch by looking under the dash, near the top of the brake pedal. The brake light switch is usually attached to a small bracket that holds the switch, activated when the pedal is depressed, in position.

What do I do if my Nissan Altima won’t start?

Here’s the hack: While in park, press the gas and the brake at the same time as hard as you can (to the floor) then push the start button while holding them down. You may need to lightly start to release the gas but keep your foot on the brake and it starts right up. He said it’s common and from moisture on the engine.

You might be interested:  What kind of oil does a 2005 nissan altima take

How do you change a brake light switch?

How to Replace a Brake Light Switch

  1. Open the driver door of the car and kneel down inside so that you can see and reach the underside of the dash, where the pedals connect.
  2. Remove the two or four Phillips-head screws that are behind the brake pedal and that hold the electrical cover in place. …
  3. Remove the cover.

Leave a Comment

Your email address will not be published. Required fields are marked *