2004 nissan frontier water pump replacement

Do you have to replace thermostat with water pump?

Most of the time, RRT will recommend replacing the thermostat at the same time as the water pump. In almost every case, the thermostat is located adjacent to the water pump and needs to be removed to access it. This saves you labor as you usually only would need to purchase the part during this job.

Can you replace a water pump bearing?

Worn or noisy bearings should be replaced immediately to prevent further damage to any related components. All bearings will wear over time with regular use and will require replacing eventually. The pump housing will need to be disassembled to access the bearings.

What are signs of bad water pump?

Symptoms of a Bad or Failing Water Pump

  • Coolant leak at the front-center of your car. …
  • Water pump pulley is loose and making whining sounds. …
  • Engine is overheating. …
  • Steam coming from your radiator.

Can you drive with a bad water pump?

However, it not advisable to keep driving a car with a bad water pump because it can lead to overheating which will eventually result in complete damage of your car engine. … With a bad water pump in a car, certainly, the car will move but, if you do not act fast by replacing it, it can cause the engine system to fail.

How long will a water pump last after it starts leaking?

The service life of most original equipment water pumps should be 100,000 miles or longer. Some cheap replacement water pumps, however, may not last 30,000 miles before they start to leak. That’s why you should recommend a top-quality replacement water pump if a customer’s old water pump has called it quits.

You might be interested:  How much is a 2011 nissan altima

What sound does a bad water pump make?

When the water pump bearings go out it will cause a squeaking, ticking or grinding noise while the engine is running. This is because the shaft bearings are trying to lock up within the pump housing. This bearing failure is due to the pressure being applied by the serpentine belt or the timing belt.

How long does it take to replace a water pump?

approximately two to three hours

Is replacing a water pump hard?

While removing the pump is not difficult, you must have experience removing and replacing timing belts and their various components. It takes just as much work to get down to the timing belt as it does the water pump, therefore you should plan on replacing the belt at the same time.

How do I stop my water pump from leaking?

Pour a liquid radiator/water pump stop-leak product, such as Bar’s Liquid Radiator Stop Leak, into your vehicle’s radiator. The radiator is usually located in the front of the engine. The liquid stop-leak product poured into the radiator will flow to the water pump seal and possibly seal or slow the leak.

How much does it cost to fix a water pump?

According to CostHelper, water pump replacement averages $300 to $750, depending on the make and model and labor costs. The water pump itself may only cost $50 to $100, but labor can run between $200 and $450, depending on the difficulty level of reaching the pump.

Leave a Comment

Your email address will not be published. Required fields are marked *