How much does it cost to replace a bad ball joint?
The ball joint is a small part of your car, and the part itself is only going to cost between $20-$150 or more, depending on where you get it from and what kind of vehicle you own. It can take a little over an hour to get it replaced, so the full ball joint replacement cost will be between $100 and $400.
Can you still drive with a bad ball joint?
Ball joints play a major role in the steering and suspension of cars and can last a long time. However, driving on bad ball joints can cause major damage and total ball joint failure can be fatal. If you’re unsure about the condition of the ball joints in a car, then speak to a garage about good quality replacements.
What are the symptoms of a bad ball joint?
Symptoms of a Bad or Failing Ball Joint (Front)
- Clunking noises coming from the front suspension. One of the most common symptoms of a problem with suspension ball joints is clunking noises coming from the vehicle’s front suspension. …
- Excessive vibration from the front of the vehicle. …
- Steering wandering to the left or right.
Can I replace a ball joint myself?
If you feel comfortable doing your own car maintenance, you can replace ball joints yourself. This can be accomplished using a tool called a ball joint press (Available through Loan-A-Tool). When considering how to use a ball joint press, it can be best to break up the task into a few specific steps.
How long can I drive with bad ball joints?
short answer is… it depends on how bad they are. the lower ball joint typically gets more wear than the upper. i’d say, if there’s just a little wiggle in either joint, you should have no problem driving 500 miles.
Do I need an alignment after replacing ball joints?
No, you certainly don’t need alignment after ball joints, unless your previous alignment was done when ball joints were bad and loose. If your car is driving sloppy after ball joints replacement, check other suspension parts.
What sound does a bad ball joint make?
Metallic clunking noise: One of the most noticeable and common symptoms of a bad ball joint is a clunking or knocking noise when the suspension moves up and down. A worn ball joint will begin to rattle inside the socket when driving over an uneven road, rough terrain, potholes or speed bumps.
How hard is it to replace ball joints?
From that standpoint, yes, it is hard to replace ball joints – more than basic DIYr skills and tools are required. There is also the safety dimension for being in close proximity to a suspended vehicle, and a compressed spring that has enough force to cause serious harm if it comes loose.
How do I know if my ball joints or wheel bearings are bad?
Diagnosis — Rocking the Tire
If the tire rocks by any noticeable degree, and especially if the movement is accompanied by a clinking or clunking sound, you likely have a bad ball joint or two. This test can also indicate a bad wheel bearing, but that will also grumble and vibrate as you drive in a straight line.
When should you replace ball joints?
3. Bad ball joint symptoms. Kloster: When a ball joint exceeds the vehicle’s manufacturer’s maximum allowance for movement, it should be replaced. Other signs of needing to replace would be a clunking noise, uneven tire wear or if the vehicle starts to pull.
Can you replace ball joint without replacing control arm?
Oftentimes, the brushings and ball joints are replaced as part of the entire control arm assembly unit — although it depends on the level of damage and wear. “They all work together,” Hawley says. “You can’t have a control arm without a ball joint.”